is my xbox is corona v3 and v5?

[mohamedwaly]

Hello
i get a 2 used as the following


1-
xbox 360 Slim E 250GB MFR:11-6-2013
according to this Xecuter Official Corona Motherboard Identification my Nand like Corona v1 "hynix KOR" but it's post_out missing
So i think it may be v5 or v6










2-the 2nd one is Xbox 360 250gb Slim S , i think it's Corona v 3 and not v5 but i want to confirm:










Please help me in Motherboard Identification for xbox 1 and 2?
and can i use R-j runner programmer v2 with them or i must buy a Nand-x?


thank you

[xboxbs]

it's easy...take a look at the pic with two red square
[url=http://team-xecuter.com/forums/threads/96752-Xecuter-Official-Corona-Motherboard-Identification-Solutions]Xecuter Official Corona Motherboard Identification & Solutions[/url]

[Babilozzo]

Hello ! Man! No problem, here all boards give with post out's removed from xgcpu. For yours xbox 1&2 nand size is still 16 MB , so it's readable/wirtable by JRP V2 with SPI wiring layout for corona. You will check nand-x/JRP corona diagram inside J-Runner "common/pics" folder!



Another thing is if you want to glitch this boards (1&2) needs to buy additional post-out adapter or soldering under xcgpu a wire.

No matter which revision is, dont'care for rgh hack the soldering points is still the same. check any diagram for corona as well. (coronaguide.jpg)
Take a look at J2C3 header and ensure the presence of resistors near it. R2C6 and R2C7 , if not you must bridge this point for sending slowdown signal (E/F) point trought i2C. That's all! man, bye bye.

[The Pusher]

you're all crazy; if v3 it has the case of xbox 360 slim , if v5 it has Xbox 360 slim E case......