Originariamente Scritto da
lapht
Before we begin, some notes regarding the 16D5S drives and why we made the choices that we made :
First of all, the SPI eeprom is locked just like in the old drives and the WP pad is connected to GND, thus making it impossible to erase/rewrite.
Why the old Geremia/kamikaze style method is not feasible in the 16D5S drives :
The area were the WP wire can be cut is less than 1mm in length and the WP bonding wire runs parallel to the DO bonding wire with around 0.1mm of separation between them.
Cutting the WP wire without damaging the DO wire is doable when the chip is decapped and under a good microscope but we can't see any way where someone can do this without some serious lab instruments.
For this reasons we have developed a replacement PCB, similar to our previous Freedom replacement PCB but with some additional hardware needed to cope with the enhanced crypto requirements in the 16D5S firmware.
This PCB will replace the original drive PCB and work on any unmodded Xbox360 (including the 4GB V2 coronas and those with dashboard 15572+ ).
The firmware is finished and stable and has all the features you would expect :
stealth, XGD3, all titles work (basically everything iXtreme 3.0 has) plus some additional features that we are testing and considering for inclusion in the final release.
Segnalibri