Toolbox 1.60 / LTU FILESET 1.1 Released
Today we have updated Lizard Toolbox in order to properly generate a LTU Firmware for LTUv2 Boards. We have also prepared the LTU 1.1 Fileset required for this process.
In order to update your tools you have 2 ways, the [URL="http://www.360lizard.com/website/downloads/Udating_Lizard_Tools_Check_for_Updates.pdf"]EASY WAY (TBX Check Updates)[/URL] or the [URL="http://www.360lizard.com/website/downloads/Udating_Lizard_Tools_LTU_step_by_step.pdf"]MANUAL WAY (step by step)[/URL]. Use whatever you feel comfortable with. Once updated you can go to the "LTU GENERATOR" tab to generate your LTUv2 Firmware.
Some WARNINGS:
- In order to generate firmware for LTUv2 you need use latest JRUNNER (2.90 or above) to generate the C-R.bin file. If you use a C-R.bin file generated with older JRUNNER the generated LTUv2 firmware WILL NOT WORK.
- At the same time if you are looking to generate LTU firmware for the LTUv1 board (if you find any on stores) you need use a C-R.bin file generated with OLDER JRUNNER (2.87), if you use newer JRUNNER the firmware WILL NOT WORK.
That is because JRUNNER 2.90 changed the C-R.bin generation for only LTUv2 hardware.
Some INSTRUCTIONS:
- To write the firmware to a BLANK LTUv2 board (fresh from the box) all you need to do is go to "Liteon->Enter MTK" on your Lizard, then go to "Liteon->Write" and flash the generated firmware for it.
- To write the firmware to an already flashed board you need to force Vendor Mode, that is by applying power while pressing the tiny "Vendor" button on the LTUv2 Board then release the button. With this you can now do the above Enter MTK and Write procedures.
- Make sure the "lock" Switch is on UNLOCK setting (WP# = 1 ) while writting to the board
7Likes
LinkBack URL
About LinkBacks
Rispondi Citando
Segnalibri